|
Question:
In the process of building a Butt and Pass 20x26 cabin. the logs are "D" cut by a friend in the area. No T&G just flat on flat. I was going to cut the logs for a 1x2 spline, But have read that the spline may cause more problems than solve. Plan on using Log hog screws every 2 foot, wondering what you would recommend between runs and exterior?
Answer:
You should run a couple of beads of Woodsman from Perma Chink between each coarse and then caulk the exterior with Energy Seal.
Add your Feedback to this question
Use the form below to post your comments to this question and answer.
| |
Question:
(500 characters max) |
|
|